Widgelix
  • Introduction
  • Get Started
    • Device Types
      • Repository
      • Create from scratch
    • Devices
      • Dashboard
      • History
      • Downlinks
      • Events
      • Settings
    • Global Map
    • Widgets
      • Gauge
      • Battery
      • Map
      • Chart
      • Digital
      • Level
      • Header
      • Image
      • Boolean
      • Scatter Plot
      • Math
      • Floor Plan
      • Asset Map
      • Heat Map
      • Log Chart
      • Downlink Button
      • Sankey
      • Report
      • Table
    • Organization
    • Global Dashboard
    • Rule Engine
  • Connectivity Integrations
    • Introduction
    • Options
      • GreenMesh LoRaWAN
      • Actility ThingPark
      • The Things Stack
      • Helium
      • Melita.io
      • LORIOT
      • Zenner
      • ChirpStack
      • Milesight
      • Senet
      • Sensoterra
      • Loxone
      • Sigfox
      • Webhook
  • Rule Engine
    • Introduction
      • Create Rule
      • IF Block
      • IS Block
      • THEN Block
      • Execution Options
    • Comparison Equations
    • Types
      • Compare with constant
      • Compare with device measurement
      • Geofences
  • Notifications
    • Introduction
    • Types
      • Slack
      • Discord
      • Email
      • SMS
  • Useful Tips
    • List of tips
  • Device Repository
    • Supported Devices
Powered by GitBook
On this page
  1. Rule Engine
  2. Introduction

Execution Options

PreviousTHEN BlockNextComparison Equations

Last updated 5 months ago

The following configurations allow you to define the frequency of rule execution:

  • Execute every <timeframe> - executes according to the defined timeframe.

  • Trigger once - executes only once.

The Enabled button switch is used to enable or disable the rule. By default, any rule you create is set to Disabled unless you turn on the Enabled button switch to enable it.